Publicidad
Step
Step 10
Carefully turn your unit over onto its front edges. Unfold the BACK (F2)
å
and lay it over your unit.
Make equal margins along three edges of the BACK (F2). The BACK
å
will overhang the BOTTOM (E2) slightly. Push on opposite corners of
your unit if needed to make it "square".
Fasten the BACK (F2) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C3).
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
Push the FOOT (3E) into the hole in the BOTTOM (E2).
å
Fasten the TIE PLATES (3G) to the BASE (H) and PLINTHS (R2). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (1S).
The BACK will overhang
the BOTTOM slightly.
R2
H
3G
www.sauder.com/services
F2
3E
E2
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the UPRIGHT (C3).
This perforation is for
the SAFETY STRAP.
R2
420613
1N
NAIL
(60 used in this step)
Cut-out (used for mirror)
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
1S
Page 15
Publicidad
