Care And Maintenance; If Service Is Required - AgraTronix HT-PRO 10 Manual Del Operador

CARE AND MAINTENANCE

1. After each use, always store your tester in a clean, dry and handy place.
2. The metal tip of the probe should be wiped clean between each use for best
results. Clean both parts of the metal tip from time to time with fi ne steel
wool and/or mineral spirits or alcohol. A dirty tip can cause lower read-
ings. Keep the brass shiny for best results.
3. Never immerse the probe in water.
4. Remove the battery, if your tester will not be used for several months.
TROUBLESHOOTING
1. Read this manual again. Carefully.
2. Clean probe tip and re-calibrate tester.
3. If "LOBAT" is displayed, replace the battery with a new 9-volt ALKALINE
battery. Re-calibrate the tester.

IF SERVICE IS REQUIRED

Call AgraTronix Customer Service at . A customer service repre-
sentative will answer your questions and explain how to return your tester for
repair or service, if necessary.
IMPORTANT: Keep original invoice or other proof of purchase. Proof of purchase is re-
quired to determine if service will be performed within the warranty period at no charge.
ASK ABOUT OUR OTHER HAY MOISTURE TESTERS
12 MODELS AVAILABLE FOR GRAIN, HAY OR SILAGE
Windrow Hay Moisture Tester
• Quickly measures loose hay and
forage from a windrow
• Time from sample to test result:
30 seconds to one minute
• Measuring range: 13% to
70% moisture
• Accuracy: +/– 2% to 4%
Ask your local retailer for more information
or call us direct at
TM
10375
1
Baler Hay Tester
• Read moisture while baling
• Fits most square and round balers
• Backlight display for night use
• Calibration check button