Description Of The Leds In The Circuit - Vimar RS01 Manual Para El Conexionado Y El Uso

RS01
4.8- Connecting the aerial
The 17cm rod is supplied pre-wired, to increase the range connect the aerial art. ZL43 as shown in the figure:

5 - Description of the LEDs in the circuit:

Abbreviation
AC Shows whether there is mains power (lit if there is mains voltage).
STPA Displays the status of the STPA input (terminal 16), if not engaged the green LED remains lit, if not used then jumper
between terminal COM and STPA.
AP/CH Displays the status of the ap/ch input (terminal 11), if not engaged the red LED remains off.
APED Displays the status of the aped input (terminal 12), if not engaged the red LED remains off.
STOP Displays the status of the stop input (terminal 14), if not engaged the green LED remains lit, if not used then jumper
between terminal com and stop.
PHOTO Displays the status of the photo input (terminal 15), if not engaged the green LED remains lit, if not used then jumper
between terminal com and photo.
FCAP Displays the opening limit switch input, if the magnetic limit switch kit is added (optional).
FCCH Displays the opening limit switch input, if the magnetic limit switch kit is added (optional).
ENC.A Displays the encoder A input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with
the motor stopped.
ENC.B Displays the encoder B input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with
the motor stopped.
DL12 Displays the programming status of the travel and of the radio control learning (two-colour LED).
Buttons in the circuit:
Abbreviation
AP/CH
P3
P2
Preliminary check:
After powering up the control unit the DL12 LED comes on for a second. Check the LEDS for diagnosis of the inputs, STOP, PHOTO and STPA must
be on.
Should one of the safety inputs (PHOTO, STOP, STPA) not be used, insert a jumper between COM and the input not used.
Fig. 12
Description
Description
Controls opening and closing the gate
Press to enter travel programming
Press to enter radio controls programming or deletion
EN
19