Emerson InSinkErator Hot1 Instalacion, Cuidados Y Uso página 3

HOW TO USE THIS INSTRUCTION MANUAL
These instructions are separated into main sections, indicated by numbers, and subsections,
indicated by capital letters. The manual is setup this way to allow you to take a break at any
point after completing a section or subsection without affecting the installation process.
What you'll see in the
instruction manual:
Provides a step-by-step narrative describing the installation step, with check boxes that
1
can be marked as you progress through the installation.
2
Contains simple illustrations that provide visual instruction to support the narrative.
CAUTIONS, WARNINGS and DANGERS that will require your attention during the step.
3
An imminently hazardous situation, which, if not avoided, will result in death or serious injury.
A potentially hazardous situation, which, if not avoided, could result in death or serious injury.
A potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
Note: The wall outlet for your
dispenser must have power
supplied to it continuously and
must be fused. It should not be
controlled by the same wall switch
that operates your disposer.
A 115-volt grounded
outlet within 30 inches
of the dispenser is
required to provide
power to the tank.
B
2
Property Damage:
Do not connect electric power until
tank is filled with water. Failure to do so my damage heating
element or thermal safety fuse and will void the warranty.
Press valve lever down for about 20
Valve
seconds until water freely runs out of
Lever
the spout. Hold valve open at lease 60
seconds to let the water run to flush
out the lines.
Water will be cold since tank has not
■
been plugged in yet.
3
1
A minimum of
3 3 ⁄ " of space
4
is required
between the
center of the
dispenser head
and splashboard/
wall in order for
the appliance to
operate properly.
3