Emerson InSinkErator Hot1 Instalacion, Cuidados Y Uso página 6

2
INSTALLING THE DISPENSER
A
B
Mounting
Rubber
Gasket
The dispenser must be mounted in
the upright (vertical) position only.
C
Spout and spout holder should not be loose
after mounting. First tighten mounting nut
and then tighten wing nut securely.
D
Personal Injury:
removal of spout. Operation of unit with spout removed
could cause injury from hot water spray
6
Nut
Spout
Rubber
Seal
Failure to tighten set screw allows easy
I I
R
emove the spout by loosening
the set screw in spout holder
approximately 2 full turns and
pull out spout.
I I
Mount the unit through the 1 3/8"
diameter (35 mm) hole in the sink.
Make sure the valve lever is in the
up position and feed the spout end
of the dispenser through the sink
mounting hole.
I I
While holding the dispenser in
place with spout removed, slip
the rubber gasket and mounting
nut over the valve lever and
hand tighten the nut on the
threaded barrel.
I I
Align spout so water runs into the
sink and secure the dispenser by
tightening the wing nut from the
underside of the sink.
Wing
Nut
I I
Reassemble the spout ensuring
the rubber seal is in place on inner
spout tube grove before re-inserting
spout into tank outlet.
I I
If rubber seal is not on spout, check
inside tank outlet. Remove and
install seal per diagram.
I I
Push spout into dispenser as far as
it will go and tighten set screw.
.