Emerson InSinkErator Hot1 Instalacion, Cuidados Y Uso página 5

START HERE
1
PREPARATION
A
Required minimum from
center of hole to wall
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
B
If you have to drill through sink or
countertop, you may need to rent or
purchase the appropriate tools.
C
Required Hole Diameter
Consult a professional before drilling into
a surface other than stainless steel.
3 ⁄ "
3
4
Maximum counter
thickness (depth)
2"
that operates your disposer.
3 ⁄ "
1
8
I I
Identify location for the dispenser.
I I
Check to make sure there is proper
clearance for dispenser handle to be
fully opened.
I I
Check to make sure counter is not
too thick.
I I
Make sure there is a grounded
electrical outlet under the sink.
I I
Turn off water supply.
I I
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
I I
Using adjustable wrench, remove
nut connecting sprayer washer
flange in sprayer hole.
I I
Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
What if you don't have a sprayer hole or
don't want to use it?
I I
Many homeowners replace the soap
dispenser in their sink with an instant
hot water dispenser.
I I
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with a
hole saw for stainless steel, or you can
use a hole punch.
5