Panasonic EY76A1 Manual De Instrucciones página 10

Changing the Belt Hook Location
EN
Side [Fig.4]
The belt hook can be attached to either
side of the unit.
WARNING!
• Be sure to attach the belt hook securely
to the main unit with the screw firmly
fastened.
• Periodically check screw for tightness.
If found to be loose, tighten firmly.
• When the main unit is held by the belt
hook, avoid jumping or running with it.
• When the unit is hooked onto the waist
belt by the belt hook, do not attach
driver bits to the unit. A sharp edge
object, such as a drill bit, may cause
injury or an accident.
How to use spare bit storage
1. Store spare bits.
1 Remove the battery pack.
2 Push it all the way into the spare bit
storage as shown in [Fig.5].
2. Remove spare bit from storage. [Fig.6]
1 Remove the battery pack.
2 Pull out the bit tip on the rear side
of the spare bit and take out the bit.
Impact Power Mode Select
The driver is preset to "Hard" impact mode
setting when shipped from the manufac-
turer.
• Selecting the impact power among 5
modes (Hard, Self-drilling screw, Soft,
Medium, Dash).
Press the impact power mode button to
set it. The mode changes to Hard,
Self-drilling screw, Soft, Medium or Dash
each time the button is pressed.
* i.p.m. = Impact per minute.
Hard
0 – 2800 rpm
and
0 – 3100 i.p.m.
• Jobs requiring high
torque.
Medium
Soft
Self-drilling screw
Dash
Avoid repeatedly depressing the switch
when the bolts and screws are securely
fastened.
Not doing so may cause a delay in rotation
starting, or the Impact Power mode
display to flash and prevent rotation from
starting for circuit protection.
- 10 -
0 – 1450 rpm
and
0 – 2500 i.p.m.
• Jobs requiring decent
torque.
0 – 950 rpm
and
0 – 1800 i.p.m.
• Jobs requiring limited
torque.
• Jobs requiring minimal
damage of finished
exterior surface.
0 – 2500 rpm
and
0 – 2800 i.p.m.
• Jobs requiring flush finish
of self-drilling screw.
Φ 4 mm × (15 mm or
smaller)
2800 rpm
and
3100 i.p.m.
• If you want to always
work at full speed and full
power regardless of the
trigger switch pull-in
amount.