Long Term Storage; Other Storage Tips; Battery Service; Battery Service (Replacement) - Generac XP Serie Manual Del Proprietário

Battery Service

3.8 LONG TERM STORAGE

It is important to prevent gum deposits from forming in essential
fuel system parts such as the carburetor, fuel hose or tank during
storage. Also, experience indicates that alcohol-blended fuels
(called gasohol, ethanol or methanol) can attract moisture, which
leads to separation and formation of acids during storage. Acidic
gas can damage the fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be emptied
before storage of 30 days or longer, as follows:
• Remove all gasoline from the fuel tank.

 Drain fuel into approved container outdoors,
away from open flame. Be sure engine is cool.
Do not smoke in the vicinity or light a cigarette.
• Start and run engine until engine stops from lack of fuel.
• While engine is still warm, drain oil from crankcase. Refill with
recommended grade.
• Remove spark plugs and pour about 1/2 ounce (15 ml) of
engine oil into the cylinders. Cover spark plug hole with rag.
Pull the recoil starter a couple times to lubricate the piston rings
and cylinder bore.
Avoid spray from spark plug holes when

cranking engine.
• Install and tighten spark plugs. Do not connect spark plug wires.
• Clean the generator outer surfaces. Check that cooling air slots
and openings on generator are open and unobstructed.
• Store the unit in a clean, dry place.

3.9 OTHER STORAGE TIPS

• Do not store gasoline from one season to another.
• Replace the gasoline can if it starts to rust. Rust and/or dirt in
the gasoline will cause problems with the carburetor and fuel
system.
• If possible, store the unit indoors and cover it to give protection
from dust and dirt. BE SURE TO EMPTY THE FUEL TANK.
• If it is not practical to empty the fuel tank and the unit is to
be stored for some time, use a commercially available fuel
stabilizer added to the gasoline to increase the life of the
gasoline.
• Cover the unit with a suitable protective cover that does not
retain moisture.
14
NEVER cover the generator while engine and

exhaust area are warm. Allow unit to cool
entirely.

4.1 BATTERY SERVICE (REPLACEMENT)

The battery shipped with the generator has been provided fully
charged. Caution must be taken when connecting the battery.
A battery may lose some of its charge when not in use for
prolonged periods of time. (See the "Know the Generator"
section.)
To replace the battery:
• Remove end panel as shown in Figure 5 in the "Know the
Generator" section.
• Remove hold-down bracket.
• Disconnect the RED battery cable to the battery Positive
terminal (+).
• Disconnect the BLACK battery cable to the battery Negative
terminal (–).
To install a new battery:
• Reverse the steps above and follow Figure 18.
• Double check all connections to ensure they are in the correct
location and secure. See Figure 18.
Figure 18 - Battery Connections
BATTERY CHARGER
GROUND
(GREEN)
NEGATIVE BATTERY
CABLE (BLACK)
POSITIVE BATTERY
SCREW
Battery Type: 12V, 10AH
NOTE:
(BLACK)
NUT
LOCK WASHER
FLAT WASHER
BATTERY CHARGER
(RED)
CABLE BOOT
CABLE (RED)