Peavey Classic 50 Manual De Instrucciones página 3

Front Panel
STANDBY SWITCH (1)
Allows amp to be placed in standby or active mode. In standby mode the tubes remain hot, but the
amplifier is not operational.
POWER SWITCH (2)
Switch to "ON" position to turn on.
CHANNEL SELECT SWITCH (3)
Allows selection of the Lead or Normal channels.
NOTE: Channel selection may also be accomplished by the remote footswitch. If remote
selection is desired the channel switch must be in the Lead position.
PILOT LIGHT LED (4)
Illuminates when AC power is being supplied to the amp.
PRESENCE (5)
An active tone control that boosts the extreme high frequencies by up to 6 dB.
MASTER VOLUME (6)
Controls the overall volume level of the system.
TREBLE, MIDDLE, AND BASS EQ (7)
Passive tone controls that regulate high, mid, and low frequencies, respectively.
REVERB (8)
Reverberation is an echo effect. Rotate clockwise to increase the effect. Remote footswitch can control
ON/OFF.
Ventilation: Allow 24" of clearance on all sides from a combustible surface.
ENGLISH
8 7
4
6 5 3
WARNING
THE ON/OFF SWITCH IN THIS APPARATUS
DOES NOT BREAK BOTH SIDES OF THE MAINS.
HAZARDOUS ENERGY MAY BE PRESENT INSIDE
THE ENCLOSURE WHEN THE POWER SWITCH IS
IN THE OFF POSITION.
1
2