install straps
• Loop straps through
saddle, placing straps
in groove on underside
of each pad.
tighten straps
• Insert end of plain strap into
buckle as shown.
secure front and rear of boat to
vehicle with bow/stern tie downs.
Refer to bow/stern tie down instructions for correct
assembly and installation.
before driving away
• Test movement by rocking boat.
• Tighten again if loose.
• READ ALL CAUTIONS AND LIMITS ON NEXT PAGE.
1033395A-3/12
OUTBOARD
• Insert PLAIN STRAP
into notch at top of
outboard saddle.
• Insert shark
chucks securely
into slot in nose
of each saddle.
• Pull strap ends to
tighten.
Failure to secure front and rear of long loads to
ends of vehicle can result in property damage,
personal injury, or death.
INBOARD
• Insert BUCKLE STRAP
into notch at top of
inboard saddle.