Miele APCL WOD Instrucciones De Montaje página 16

M.-Nr. 11477230
en-US
APCL WOD stand installation instructions
Reason: Installing a washer or dryer on a stand enables a more ergonomic height to be achieved.
Parts included
Quantity Mat. no. Designation
1 Stand
4 20 l canister (APCL022, APCL024 only)
6 20 l canister (APCL023 only)
2 Clamp
4 B6.4 galvanized washer
2 M6x30 bolt
4 M6 nut
2 Clamping plate
4 CEM 6 x 12 raised-head screw
2 M6x20 bolt
Danger due to incorrectly carried out service and repair work
WARNING

Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Measures to be carried out before starting any service work
- Carry out appropriate electrical safety checks.
- Disconnect all machine utility connections in accordance with the operating instructions.
Measures to be carried out after service work has been completed
- Carry out appropriate electrical safety checks.
- Check the appliance for correct operation.
Risk of cuts
WARNING

Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection (mat. no. 05057680) should be used.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
16 von 55
18.03.2021