Miele APCL WOD Instrucciones De Montaje página 7

M.-Nr. 11477230
Danger of injury due to excess physical strain
WARNING

Danger of injury due to excess physical strain.
Spinal injuries.
A
The relation of the weight of the machines to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Preparing the plinth
A
Use 2 screws (6 x 12) to attach each of the clamping plates to the rear of the plinth, see Fig. 1.
The arrow embossed on the top of the plinth points to the front, see Fig. 1.
A
Level the plinth on the floor.
The flooring must be level and dry with no traces of dirt or grease.
A
Unscrew the front panel.
A
Fill all the media canisters with water and seal them tight. Leave the drain valve closed at all times.
A
Place 2 media canisters into the plinth and line them up with the rear of the plinth.
A
When using an APCL023 plinth, place 2 additional media canisters into the plinth and line them up with the front of
the plinth.
A
Place the final 2 media canisters into the plinth.
Take great care when placing the media canisters into the plinth. Leave the drain valves closed at all times.
Check that the fill level in the system is constant at regular intervals.
Fitting a washing machine to the plinth
A
Fit the clamps to the front of the plinth and fasten them in the appropriate holes, see Fig. 2.
A
Secure each clamp to the plinth with 1 M6 x 30 bolt (1), 2 galvanised B6.4 washers (2) and 1 M6 nut (3). Do not
tighten the nuts yet, see Fig. 3.
A
Unscrew the washing machine feet by at least 5 mm.
A
Set the washing machine down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the washing machine on the plinth.
A
Use the clamps to fix the washing machine to the front feet, see Fig. 3.
A
Fit another M6 nut (4) to each of the feet to counter the first nut, see Fig. 3.
A
Screw 1 M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 4.
A
Screw the front panel of the plinth back into place.
Fitting a tumble dryer to the plinth
A
Unscrew the tumble dryer feet by at least 5 mm.
A
Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the tumble dryer on the plinth.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 5.
A
Screw the front panel of the plinth back into place.
en
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
7 von 55
18.03.2021