Harbor Breeze 40105 Manual De Usuario página 14

ASSEMBLY INSTRUCTIONS
INITIAL INSTALLATION
21. Position one blade arm (J) under a blade (I) and
secure them together with three blade screws (BB)
and blade washers (CC). Do not tighten the blade
screws (BB) until all three have been started. Tighten
each blade screw (BB) starting with the center blade
screw (BB). Repeat this step for all blades (I).
Hardware Used
BB
Blade Screw
CC
Blade Washer
22. Insert one blade assembly into one of the slots on
the flywheel (T). Align the mounting holes on flywheel
(T) and blade arm (J), securing with motor screws
(DD). Repeat for the remaining blade assemblies.
Hardware Used
DD
Motor Screw
23. Remove one of the switch housing plate screws (LL)
from the fitter plate (R), and loosen (do not remove)
the other two screws. Insert the wires from the motor
housing (F) through the hole in the switch housing (G).
Hardware Used
Switch Housing
LL
Plate Screw
3
21
x 15
x 15
22 3
x 10
T
23
x 3
R
14
BB
I
CC
J
T
DD
F
G
LL
Lowes.com/harborbreeze
J