ASSEMBLY INSTRUCTIONS
27. Install the 40-watt bulbs (Q) into each socket on the
light kit (H).
CAUTION: An energy-saving wattage limiter is
included with the fan. When replacing bulbs, ensure
bulb wattage is less than 190 watts, otherwise the
fan will not function.
28. Lift the glass bowl (K) up to the light kit (H), allowing
the preassembled threaded rod to go through the
center hole in the bottom of the glass bowl (K). Secure
glass bowl (K) with rubber washer (II), flat washer
(HH), hex nut (JJ), finial cap (L), then finial (M).
Hardware Used
HH
Flat Washer
II
Rubber Washer
JJ
Hex Nut
27
Q
28
x 1
x 1
x 1
16
H
H
II
HH
JJ
M
Lowes.com/harborbreeze
K
L