Tabla de contenido
Publicidad
3
5
Install the door sweep
3
5
onto each door by
gently tapping the
sweep into the grooves
on the door bottom.
Important: Make sure the longest fin
on the sweep faces the inside of the
building when installed.
3
7
Tap door pins in both top and bottom hinges
3
7
with hammer. Repeat to install right door.
Install door lock hardware (not provided) in
pre-drilled hole in door.
Note: For proper door alignment, there
should be a 1/4" (.63cm) gap between the doors and
between each door and the front wall.
3
8
3
8
Install door handles in pre-drilled
holes with curved end of handle
facing outside of building.
36
36
door is (a) with the etched crown right-side up
and facing you and (b) with the larger opening
of the beveled screw holes facing you. The cor-
rect position of the hinge for the right door is (a)
with the etched crown upside-down and facing
you and (b) with the larger opening of the
beveled screw holes facing you. Line up hinge
plates so that they are parallel with the back of
the door frame as in the diagram below. Make
sure that the two prongs are facing outward.
Insert the two outside screws first to ensure the
hinge is properly aligned.
3
9
Next, install
3
9
Astrigal on
left door of
the build-
ing. Position
Astrigal on inside of left
door so that the screw
locator holes on the
Astrigal are positioned on
the left door and the posi-
tioning fin on the Astrigal
fits tightly against edge of
left door. Mark hole loca-
tions on left door while
holding Astrigal in place.
Drill 1/16" diameter holes,
making sure that the drill
does not penetrate the
exterior side of the door.
Install Astrigal with
#10x3/4" screws provided.
14
THE BALMORAL
Before you attach the hinge
plate please identify the correct
position of the hinge using the
diagram to the left. The correct
position of the hinge for the left
Astrigal
Door
Publicidad
Tabla de contenido
