General Assembly - Royal Outdoor Products PREMIER Serie El Manual Del Propietario

THE BALMORAL
3 Back and Side Wall Assembly
3
Parts Needed:
2 Corner Posts
10 Side Wall Joiner Panels
8 Side Wall Groove Panels
5 Back Wall Joiner Panels
4 Back Wall Groove Panels
(Right and left are determined when facing the front of the building.)
It's helpful to lay out all the required panels on the ground around
your foundation in their proper sequence. Note that the back wall
panels are angled at the top edge and vary in length.
6
6
labeled JT3–PT2–JT2
into rear base channel.
Install the
group of 3
pre-assem-
bled back
wall panels
4

General Assembly

4
The Joiner and Groove Panels are designed to make
assembling your building easy. The Joiner Panel and
Groove Panel slide together easily without additional
lubricants. There is not an inside or outside surface to the panels.
Some panels are shipped pre-assembled in groups of 3 or 4. Due to
the weight of the pre-assembled panels, you may find it necessary to
disassemble some groups of 3 or 4 in order to assemble your building.
Joiner Panel
First, insert a
5
5
group of 3 pre-
assembled side
wall panels
labeled JT1-
PT1-JT1 into side base
channel at right rear cor-
ner. Make sure a joiner
panel faces the corner.
7
7
Groove Panel
7 Install a corner post.