10 www.electrolux.com
Problem
The buzzer sounds.
The Alarm light
flashing.
The compressor op-
erates continually.
The temperature in
the freezer is too
low.
The temperature in
the freezer is too
high.
Upper or lower
square is shown in
the temperature dis-
play.
Possible cause
The appliance has no
power. There is no voltage
in the mains socket.
The temperature in the
freezer is too high.
The door is not closed
correctly.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
The FastFreeze mode is
switched on.
The temperature regulator
is not set correctly.
The FastFreeze mode is
switched on.
The temperature regulator
is not set correctly.
Many products are stored
at the same time.
Products are too near to
each other.
An error has occurred in
measuring the tempera-
ture
Solution
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Refer to "Excessive Tem-
perature Alarm".
Refer to "Door open alarm".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
Refer to "FastFreeze
mode".
Set a higher temperature.
Refer to "FastFreeze
mode".
Set a lower temperature.
Store less products at the
same time.
Store products so that
there is cold air circulation.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).