Health O Meter 2500 KL Instrucciones De Uso página 16

2600KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Ramp Assembly Instructions
1. Follow these instructions for moving the ramp to the opposite side of the scale, or for
adding a second ramp to the scale (B2600RAMP option):
2. On the side of the platform opposite to the ramp, remove the guardrail mounted to the end
of the platform by unscrewing and then removing the 4 guardrail assembly screws (see
Figure 3).
3. Fold the ramp onto the platform surface.
4. Remove the screws attaching the 2 rubber bumpers, located on the side of the platform
(see Figure 10).
5. Remove the bumpers, and re-install them on the opposite side of the platform. Use the
appropriate mounting holes (see Figure 10).
6. Loosen the screws holding each ramp holder to the platform.
7. Remove the ramp from the ramp holders. Remove the ramp holders by pulling out on
them slightly.
8. Install the ramp holders at the opposite side of the platform, but do not tighten the screws.
9. Insert the ramp between the ramp holders, and tighten the assembly screws.
10. Install the guardrail on the opposite side of the platform.
Note: It is necessary to make small clearance holes in the mat in order to re-install the
guardrail assembly screws (the mounting holes are located beneath the mat). Use an awl or
small Phillips screwdriver to make the holes. Use the guardrail as a guide to locate the two
holes beneath the mat.
Note: A second ramp is available separately as B2600RAMP.
16