Health O Meter 2500 KL Instrucciones De Uso página 8

2500KL ASSEMBLY INSTRUCTIONS (CONTINUED)
14. Align the four mounting holes on the back of the display assembly with the four mounting
holes in the display support. Fasten the display assembly onto the metal display support.
Use the (4) Phillips pan head #5 x 3/8 screws (C) (see Figure 1).
15. Place the pivot bracket screw covers over the pivot screws. Fasten the covers to the
back of the display assembly using the (4) Phillips pan head #5 x 3/8 screws (C) (see Figure
1).
16. Attach the adapter holder to the left side of the handrail using the (2) #8 x ½ sheet metal
screws (B) (see Figure 1).
17. Connect the AC adapter to the power port, located on the back of the display assembly.
Caution: Do not plug the scale into a power source until the scale is fully assembled.
18. Rotate the display to align it parallel to the handrail. Attach the front and rear display
support covers by applying light pressure while snapping the covers into place.
19. The scale is now assembled. Plug the AC adapter into a power source and / or insert the
batteries.
8