Silverline SDS Plus Traducción Del Manual Original página 8

GB
Drilling wood
• Use rotary drill mode only
• Ensure drill bits are suitable for wood and are within the maximum
capacity of this drill
Drilling metal
• Use rotary drill mode only
• To ensure accuracy, mark the intended hole position using a hammer
and centre punch
• Ensure drill bits are suitable for the grade of metal being drilled, and are
within the maximum capacity of the drill
• To ensure efficient cutting, and prolong drill bit life, use a suitable
lubricant/cutting fluid
CAUTION: Applying excess pressure does not result in faster or more
efficient drilling. If the pressure applied to the drill has a noticeable effect
on the speed of the drill then reduce the pressure. Overloading the drill will
reduce its service life.
• As the drill bit penetrates the material being drilled, it may 'catch' or
'snag'. This can cause the machine to suddenly 'kick'. Prevent any
possibility of injury by always holding the drill securely, using the auxiliary
handle, and using sharp drill bits
• Always ensure material is secure. If appropriate use a vice or clamp to
hold the workpiece, and always keep two hands on the drill
Accessories
A range of accessories for this product are available from your Silverline
dealer including SDS Plus drill and chisel bits. Carbon brushes are available
from www.toolsparesonline.com or your Silverline dealer.
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying
out any inspection, maintenance or cleaning.
Gearbox maintenance
• After every 6 hours of use (approx.), the gearbox must be re-greased
1. Use the Hex Key (19) to remove the Gearbox Cover (4)
2. Use a spatula or similar instrument to apply grease into the gearbox
cavity until it is full
Note: Take care not to scratch or otherwise damage the mechanism
3. Replace the Gearbox Cover (4)
• A Pot of Grease (14) is supplied for the first few re-greases but additional
lubrication will be required. When purchasing, select a general purpose
lithium-based grease
• Do not over-tighten the gearbox cover or overfill the gearbox with grease
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Silverline service centre.
This advice also applies to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts
to wear quickly and shorten the machine's service life. Clean the body of
your machine with a soft brush, or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do
not use alcohol, petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant
8 8
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• To replace the brushes, remove the Motor Vents & Brush Access Cover
(8). The worn brushes can then be withdrawn, and replaced with new.
Always replace worn brushes in pairs. Refit the brush access cover.
Alternatively, have the machine serviced at an authorised service centre
Storage
• After use return the drill and accessories to the supplied case and store
in a damp-free environment, out of reach of children.
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools