Maytag MFT2776FEZ Manual De Uso Y Cuidado página 30

PROBLEM
The motor seems to run
too much
The lights do not work
Shelves with under-shelf
LEDs do not light up
(on some models)
Pantry Temperature
Control not lit/
unresponsive
30 30 30 30 30 30
POSSIBLE CAUSES
High efficiency compressor and fans
The room or outdoor temperature is
hot.
A large amount of warm food has
been recently added.
The door(s) are opened too frequently
or for too long.
The refrigerator door or freezer drawer
is ajar.
The refrigerator control is set too cold. Adjust the refrigerator control to a less cold setting until the
The door or drawer gasket is dirty,
worn, or cracked.
Your refrigerator is equipped with LED
lighting which does not need to be
replaced.
The dispenser light is set to OFF.
Doors have been open longer than
10 minutes.
Shelf hooks are not fully engaged in
shelf supports.
Shelf supports, fastened to the back
wall of the refrigerator cabinet, are
loose
Doors have been open longer than
10 minutes.
The refrigerator is in Cooling Off
mode.
The refrigerator controls' initialization
process did not complete
successfully.
SOLUTIONS
Larger, more efficient refrigerators run longer at lower, more
energy efficient speeds.
It is normal for the refrigerator to work longer under these
conditions. For optimum performance, place the refrigerator
in an indoor, temperature controlled environment. See
"Location Requirements."
Warm food will cause the refrigerator to run longer until the
air cools to the desired temperature.
Warm air entering the refrigerator causes it to run more.
Open the door less often.
Make sure the refrigerator is level. See "Refrigerator Leveling,
Door Closing and Alignment." Keep food and containers
from blocking the door.
refrigerator temperature is as desired.
Clean or change the gasket. Leaks in the door seal will cause
the refrigerator to run longer in order to maintain desired
temperatures.
If there is power to the refrigerator and the lights do not
illuminate when a door or drawer is opened, call for service
or assistance.
On some models, the dispenser light will operate only when
a dispenser paddle is pressed. If you want the dispenser light
to stay on continuously, see "Water and Ice Dispensers."
Close the doors and drawer to reset, and open to resume
lighted task.
Check that the rear shelf hooks are completely seated into
the slots in the shelf supports.
Check all shelf support screws to ensure they are fully
tightend. Tighten all loose screws.
Close the doors and drawer to reset, and open to resume
lighted task.
Exit Cooling Off mode. See "Using the Control(s)."
Unplug the refrigerator, wait 5 seconds. Plug in the
refrigerator, and wait 30 seconds before opening any of the
refrigerator doors or touching the control panel.