Bolt-down instructions
To provide water-resistance this safe must be bolted down. (hardware supplied)
Bolt down kit contents:
2 Lag screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
9/32" (7.2 mm) drill bit – for drilling into wood
3/8" (9.5 mm) drill bit – for drilling into masonry
1
2
3
F
F
NOTE: SentrySafe is not responsible for any costs incurred if unit is to be replaced.
F
Bolt-down instructions
Select a suitable and convenient location for your safe. Set the
safe in place and use the holes provided in the bottom or back
of the safe to mark the location of the holes to be drilled in the
floor.
Move the safe away and drill holes of the appropriate diameter
and depth for the type of hardware and the mounting surface
being used (2 each – bolts, washers and masonry anchors).
Place the safe back over the holes and install the fasteners as
required. If a water resistant unit was purchased, rubberized
washers are provided. Assure that the area around the safe
hole opening is clean using a damp cloth. Place the rubber side
of the washer facing down against the safe floor and install
the fastener.
4