Bolting Down Your Safe; Bolt Down Instructions - SentrySafe Fire-Safe SFW123ES El Manual Del Propietario

Bolting Down Your Safe

Bolt down instructions

Warning: Product is not water resistant once it is bolted down. The ETL verified water
resistance claim applies to product prior to the application of a bolt-down kit.
Bolt down kit contents (in select models only):
Tools needed to bolt safe to the floor:
7
⁄ " (11 mm) drill bit – for drilling into the safe.
16
9 ⁄ " (7.2 mm) drill bit – for drilling into a wood floor.
32
3
⁄ " (9.5 mm) drill bit – for drilling into a masonry floor.
8
1 Tip the safe onto its left side (door hinges horizontal with the floor).
2
3
Tip the safe upright, place the safe in the desired location and open the door.
4
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Unlock the safe and open the door. Look to the bottom of the
safe for two indentations on the feet in opposite corners. Using
the 7 ⁄ " (11 mm) bit; drill a hole through each indentation
16
perpendicular to the bottom of the safe. Do NOT drill from
any location inside the safe.
Use a screw or pencil to mark the floor through both holes.
11