Lock Instructions - SentrySafe EF3428E Manual Del Propietário

Lock instructions

Standard Electronic Lock
To activate lock:
Four alkaline AA batteries, Voltage: 6Vdc, (not included) are required to activate the keypad.
NOTE: Do not use rechargeable batteries or any other type of non-alkaline battery. Do not mix
old and new batteries. Do not mix alkaline and standard batteries.
To install batteries
1
2
Install four alkaline AA batteries as illustrated on the back of the battery holder.
3
Reconnect the keypad by inserting the keypad's four posts into the matching holes.
4
Push down to snap into place.
5
NOTICE
Test first with door open!
(See back cover of this manual for your factory code.)
Access codes
CONFIDENTIAL
Using two hands, hold the keypad, thumbs down, on its left and
right sides. Push up the keypad with your thumbs, and disconnect
it from the safe by pulling it towards you.
Let the disengaged keypad hang by its wires. This will expose the
battery holder.
There are three possible ways to unlock and access the safe—by entering
its preset Factory Code, your own User Code or a User PIN (Personal
Identification Number).
You can always open the safe by entering the 5-digit Factory Code. This
code cannot be deleted.
But if you prefer to use your own code, you can program the safe to open
to the 5-digit User Code of your choice. If you wish to give someone else
temporary access to the safe, you can program a User PIN that can later
be erased.
5