Radio Operation - riptunes CDB300 Guia Del Usuario

RADIO OPERATION

Antenna
For best reception, fully extend the FM Antenna to receive FM stations. For AM reception, the unit has a
built-in antenna. To improve AM reception performance, turn the whole unit until optimal reception is
achieved.
Basic Operation
1. Press the FUNCTION button to turn the unit on. Press again until FM or AM Tuner is indicated on
the display screen.
2. Adjust the frequency manually by using the
For Automatic Tuning:
Press and hold the
When a station of sufficient strength has been found, tuning will stop or you can stop the
automatic tuning by pressing
Repeat until you have found the desired station.
3. To turn off the radio, press and hold the
Preset Tuning
1. Select the AM/FM band and tune to your desired station by following the procedures described above.
2. Press the MEM/PROG button.
3. Use the M+ or M- button to change the number where the station will be stored. (1-20)
4. Press the MEM/PROG button again to store the current frequency to the number selected.
5. Repeat the same procedure to set other desired frequencies into one of the 20 memory slots.
Notes: A stored frequency can only be erased by storing another frequency in its place.
The unit can be preset up to 20 stations.
Accessing PreSet stations
Recall the stored frequencies by pressing M+ or M- buttons to select the desired station.
buttons.
or buttons until the display frequency adjusts automatically.
or button again.
FUNCTION button.
- 8 -