Technical Description; Description Of The Device; Connecting The Inverter - Dometic Waeco PocketPower TSI102 Instrucciones De Uso

TSI102.book Seite 15 Donnerstag, 27. Oktober 2011 6:12 18
PocketPower TSI102
5

Technical description

The device has a compact design for portable use. The heat generated during operation
is dissipated by a fan inside the device.
5.1

Description of the device

No. in
Description
fig. 1, page 3
1 Status LED blue
2 Negative contact
3 Positive contact
4 230 V output
5 USB charger connection
6

Connecting the inverter

Caution!
a
The cable between the battery and the inverter may not exceed a maximum
length of 2 m.
Caution!
a
Make sure the plug (fig. 1 4, page 3) is firmly connected to the vehicle socket.
If the connection is loose, the plug may heat up and cause the inverter to mal-
function.
Caution!
a
Do not operate any connected power consuming device while driving the vehi-
cle. Only operate device when vehicle is stationary.
Note
I
If you connect the device to the cigarette lighter, remember that the ignition must
be turned on to supply it with power.
➤ Fasten the inverter as follows (fig. 2 3, page 3):
– Screw the rail to the floor.
– Push the inverter onto the rail.
➤
Insert the plug into a 12 V cigarette lighter socket or into a 12 V vehicle socket.
The middle pin (fig. 1 3, page 3) of the plug must be connected to the positive (+)
wire and the two side brackets (fig. 1 2, page 3) of the plug must be connected to
the negative (-) wire.
EN
Technical description
15