Technical Description; Connecting The Inverter; Fastening The Inverter - Dometic WAECO PerfectPower PP402 PAD Instrucciones De Uso

PP402 PAD, PP404 PAD
5

Technical description

The PerfectPower inverter can be operated wherever there is a 12-Vg or a
24-Vg connection. The devices are additionally cooled with a load and tem-
perature-dependent fan.
The maximum constant output for the devices is 350 W.
The inverter is equipped with protection against thermal and electrical over-
loading, as well as excess and insufficient voltage. The inverter switches off:
 If its internal temperature is too high
 If the load exceed the values stated above
 If the input voltage is too high or too low
The inverter can be switched on and off using the switch directly on the
device or using an external switch.
6

Connecting the inverter

6.1

Fastening the inverter

You can fasten the inverter using the four holders supplied.
When selecting the installation location, observe the following instructions:
 The inverter can be mounted horizontally or vertically.
 The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, enclosed spaces. The clearance
around the inverter must be at least 25 cm (fig. 4, page 4).
 The air intake on the underside or the air outlet on the back of the inverter
must remain clear.
 For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to the automatic shut-off of the inverter.
 The installation surface must be level and sufficiently sturdy.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
EN
Technical description
27