Connecting The Inlet Hose; Method1 - Using The Y Connector And Long Hose - Samsung DV5471A Serie Manual Del Usuario

Secadora a gas y eléctrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

installing your dryer

CONNECTING THE INLET HOSE

Method1 - Using the Y Connector and Long Hose

The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
1. Turn off the cold water faucet.
2. If you have a washer water hose attached to the cold water
faucet, unscrew and remove the hose.
3. If space permits, attach the brass female end of the
"Y"connector to the cold water faucet. Turn by hand until
tight.
4. Attach the straight end of the long hose to the "Y' connector.
Screw on the hose coupling by hand until it is tight.
5. Using pliers, tighten the hose coupling with an additional two
thirds turn.
Do not overtighten. You can damage the coupling.
6. Attach the angled end of the long hose to the fi ll valve at the
bottom of the dryer's rear frame. Screw on the coupling by
hand until it is tight.
7. Using pliers, tighten the hose coupling with an additional two
thirds turn.
Do not overtighten. You can damage the coupling.
8. Attach the washer hose to the other side of the "Y" connector. Screw on the hose coupling until
it is tight. Using pliers, tighten the coupling with an additional two thirds turn.
Do not overtighten. You can damage the coupling.
9. Turn the water faucet on.
10. Check for leaks around "Y" connector, faucets, and hoses.
20_ Contents
DV5471AE-03022A-02_EN.indd Sec2:20
DV5471AE-03022A-02_EN.indd Sec2:20
Y-Connector
Water Hose
Duct Exhaust
Frame
(back)
Water Hose
2011-04-12
2011-04-12
11:37:08
11:37:08

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dv5451a serie

Tabla de contenido