Braun FreeGlider 6610 Manual De Instrucciones página 12

What to do if ...
Problem
Shaving Conditioner is leaking Foil frame replaced incorrectly Remove foil frame and attach once more,
None, or too little Shaving
Conditioner dispensed with
new shaver
None, or too little Shaving
Conditioner dispensed after
longer use
Skin is red or burns
Shaver is connected to the
mains, but is not charging
(green LED does not light up)
Shaving head does not swivel
Cartridge cannot be removed
Water condensation inside the
cartridge compartment
12
Situation
or
Applicator replaced
incorrectly
or
Shaver was switched on with
foil frame removed
or
Cartridge was removed
immediately after use
No cartridge inserted
or
Sealing foil not removed from
cartridge
or
Scale positioned at «min»
Applicator clogged
or
Cartridge empty
Skin is not used to Shaving
Conditioner
Shaver is completely
discharged
Head lock activated
Pull-out tag was accidentally
removed from cartridge
Differences in temperature
when cleaning with water
Solution
ensuring both sides click audibly into
place. If needed, clean both foil frame and
shaver head.
Place new applicator on the foil frame,
leaving a small gap. With both thumbs
push applicator right and left until it clicks
into place.
Do not switch on when foil frame is
removed.
Do not remove cartridge immediately after
use.
Insert cartridge.
Remove sealing foil.
Move scale.
Replace applicator (before shaving do
not use moisturizing creme or lotion).
Insert new cartridge.
Conditioner contains alcohol. Sensitive
skin might require 1 to 2 weeks to get
accustomed. If your skin shows signs of
intolerance, discontinue using the Shaving
Conditioner.
Leave shaver connected to an electrical
outlet, push start/stop button once. Shaver
will be charging when green LED lights up.
Release head lock.
Use appropriate tool (flat-nose pliers) to
pull out cartridge. When inserting a new
cartridge, only remove the silver sealing
foil. Do not remove the transparent pull-out
tag.
Condensation will disappear after a
while and has no effect on the shaver's
operation. The electronics section is sealed
against water.