Tabla De Contenido; Tools Needed For Assembly - PEERLESS SmartMount RTFPA50U Serie Instalación Y Ensamblaje

Note: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call
Peerless customer care at 1-800-729-0307.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum UL Load Capacity.
• If mounting to wood wall stud wall construction, make sure that mounting screws are anchored into the center of the
studs. Use of an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power. See suggested torque values where applicable within these instructions.

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• pencil
• drill
• 3/16" drill bit for wood studs, 5/16" drill bit for concrete
• 7/16" socket wrench or bit driver
• level
• tape measure
Table of Contents
Parts List .......................................................................................................................................................................... 3, 4
Adjustment of Arm ................................................................................................................................................................ 5
Installation to Double Wood Stud Wall .................................................................................................................................. 6
Installation to Solid Concrete and Cinder Block .................................................................................................................... 7
Installing Universal Adapter Bracket ...................................................................................................................................... 8
Attaching Adapter Plate to Screen with VESA
Installing and Removal of Flat Panel Screen ....................................................................................................................... 13
Adjustment of Flat Panel Screen ........................................................................................................................................ 13
Cable Management ............................................................................................................................................................. 14
For customer care call (800) 729-0307 or (708) 865-8870.
WARNING
for wood screws
® Mounting Patterns .................................................................................... 12
2 of 42
ISSUED: 03-08-07 SHEET #: 095-9264-2 10-26-09