Adjustment Of Arm - PEERLESS SmartMount RTFPA50U Serie Instalación Y Ensamblaje

Adjustment of Arm on Wall Plate
NOTE: If mounting wall plate (D) to wood stud wall surface, slots on wall plate (D) must align to studs.
1
Determine desired location of screen center (refer to step 2) as shown in fig. 1.1, then hook arm onto wall plate (D)
as shown in fig. 1.2.
Using 3/16" allen wrench (L), secure arm (A) to wall plate (D) using two 5/16-18 x 1.75" flat head socket screws (I)
and two 5/16"-18 nuts (J) as shown in fig. 1.3. NOTE: BOTH 5/16-18 x 1.75" flat head socket screws (I) must be
fastened to to wall plate securely using 5/16"-18 nuts (J). Do not adjust arm while screen is attached.
A
CS = center of screen
fig. 1.1
D
I
A
Slots will align
on studs
D
J
fig. 1.3
5 of 42
fig. 1.2
A
ISSUED: 03-08-07 SHEET #: 095-9264-2 10-26-09
D