Operation - Klarstein CoolZone 250 Manual Del Usuario

Screw two middle brackets with wooden cabinet by short
screws. Then fit middle bracket covers with brackets at two
sides.

OPERATION

Before first Use
• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the refrigerator; tear off the protective film on the doors and the
refrigerator body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the refrigerator; do not put the refrigerator in moist places
easy to be splashed with water so as not to affect the electrical insulation properties
of the refrigerator.
• The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat,
and sturdy (rotate left or right to adjust the wheel for levelling if unstable).
• The top space of the refrigerator shall be greater than 30 cm, and The refrigerator
should be placed against a wall with a free distance more than 10 cm to facilitate
heat dissipation.
• Before initial start, keep the refrigerator still for half an hour before connecting it to
power supply.
• Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3
hours, or for above 4 hours in summer when the ambient temperature is high.
• Spare enough space for convenient opening of the doors and drawers.
9
EN
29