An Overview Of The 154Xst Series - Federal Signal 154XST Serie Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

An Overview of the 154XST Series

Federal Signal's Model 154XST hazardous location strobe light
provides 80 high-intensity flashes per minute. This warning light
is available in 24 Vdc with a 4-wire supervisable power circuit for
fire alarm and suppression supervised control panels.
The Model 154XST strobe light is UL and cUL Listed and CSA
Certified for Class I, Division 2, Groups A, B, C and D; Class II,
Division 1, Groups E, F and G; and Class III.
The 154XST meets Type 4X water-tight, dust-tight, and corrosion-
resistant requirements; constructed to IP66. This hazardous
location warning light has an aluminum base, coated for corrosion-
resistance that is ready for mounting on a 3/4-inch NPT pipe. The
included dome guard fits over the glass dome to protect it against
accidental collision with moving equipment, such as forklifts. An
optional wall bracket is also available.
The 154XST has an effective candela (ECP) of 165 and a 520,000
peak candela. It is available in six dome colors, including amber,
blue, clear, green, and red (magenta upon request).
Federal Signal's rugged 154XST strobe warning light is
specifically designed for hazardous locations or corrosive
environments where a very bright visual signal is required.
This warning light can be used for plant evacuation or other
communication needs.
Models are available for pipe mounting (154XST) or surface
mounting (154XST-S).
NOTE: The 154XST can be mounted to a Federal Signal Model
LHWB bracket. If installed in this way, the entire assembled
device is suitable only for Class I, Div. 2, Groups A, B, C, and D;
Class II, Div. 2, Groups F and G; Class III locations.
Models 154XST and 154XST-S
6