Figure 1 Pipe-Mounted Beacon - Federal Signal 154XST Serie Instrucciones De Instalación Y Mantenimiento

The Model 154XST has provisions for mounting a 3/4-inch pipe
and can be mounted in any position.
To pipe-mount the beacon:
1. Before mounting the beacon, ensure that the mating threads
are clean.
2.
To prevent the ingress of water and dust, apply conductive
sealant to the conduit threads prior to mounting. If non-
conductive sealant is used, the enclosure must be earthed
via the provided internal grounding wire/grounding screw to
ensure proper grounding continuity (Figure 3 on page 12).
3.
Thread the fixture onto the 3/4-inch pipe and secure it with the
set screw.
3/4" NPT PIPE
Installation and Maintenance Instructions

Figure 1 Pipe-mounted beacon

Models 154XST and 154XST-S
154XST LIGHT
ASSEMBLY
SET SCREW
290A6908
9