Cleaning The Fixture; Lubricating The Threaded Joint; Getting Repair Service Or Technical Assistance - Federal Signal 154XST Serie Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Cleaning the Fixture

EXPLOSION HAZARD—Never use an abrasive material
or file to remove corrosive materials from threaded
surfaces. In extremely corrosive locations, equipment
should be periodically inspected to guard against unusual
deterioration and possible porosity, since this may weaken
the enclosure structurally.
Maintenance procedures sometimes require fixtures to be hosed
down for good housekeeping. The circuit should be turned off
prior to hosing down the fixture.
The fixture should be cleaned periodically to maintain
maximum light output. Only mild, non-abrasive cleaning agents
should be used. The glass globe should be regularly inspected
for scratches and chips, and if damaged, MUST be replaced.

Lubricating the Threaded Joint

The threaded joint on the cover should be kept well lubricated
with a corrosion inhibiting grease such a petrolatum or soap-
thickened mineral oil. If corrosive materials have accumulated
on the threaded joints and cannot be removed with solvents, the
parts should be discarded and replaced.

Getting Repair Service or Technical Assistance

Products returned for repair require a Return Authorization form
from your local distributor or from Federal Signal. To obtain
repair service or technical assistance from Federal Signal, call
708-534-4756 or 877-289-3246. For instruction manuals and
information on related products, visit:
http://www.federalsignal-indust.com
18
Models 154XST and 154XST-S