Starting The Unit; Engine Operation; Standard Display; Entering The Setpoint Temperature - Thermo King Ce-Serie Manual Del Operador

OPERATING INSTRUCTIONS

STARTING THE UNIT

Engine Operation

1. Start the truck engine. The Dot Symbol will
remain lit.
2. Press the On/Off switch located in the In-cab
Control Box for at least 1 second. The In-cab
Control Box display will be activated.
3. Check the setpoint, and adjust if necessary.
Note: Regular monitoring of the unit is
recommended, the frequency of this monitoring
will depend on the type of cargo.

STANDARD DISPLAY

This is the display that appears when the ON/OFF
key is pressed 1 second and the unit started. It
normally displays the return air temperature and
the current operating mode with the appropriate
symbol.
Should there be an alarm, the alarm symbol will
also appear on screen.
12
The example in the drawing shows: 10ºC
temperature, cool mode.
ENTERING THE SETPOINT
TEMPERATURE
The Setpoint Temperature can be quickly and
easily changed.
1. Press and release the SET key once, and the
letters SP will appear on screen.
2. Press SET key again and the current Setpoint
Temperature will appear on screen.
3. Press the UP or DOWN arrow keys to select the
desired Setpoint Temperature. Each time either
of these buttons is pressed and released, the
Setpoint Temperature will change 1 degree.
Setpoint Temperature will also change
continuously if UP/DOWN key is continuously
pressed without release
4. Press and release the SET key to set the
setpoint
5. Press and release ON/OFF key twice to return
to the Standard Display.
CAUTION!
If the SET key is not pressed within 20 seconds
to select the new Setpoint Temperature, the unit
will continue to run at the original Setpoint
Temperature.