Configuring Kts Truck Mac Address - Bosch KTS Truck Manual Original

en 26 | K�S �ruck | Commissioning
Procedure:
1. End all open applications.
2. Start Bluetooth driver installation via "Start >> All
Programs >> Bosch ESI[tronic] 2.0 >> Bluetooth
Installation".
 Set-up is started.
3. Heed and follow the instructions on the screen.
4. Plug Bluetooth USB adapter into USB interface
of PC/Laptop.
5. Continue installation with <OK>.
6. Re-start the PC/Laptop with <Yes> to successfully
conclude installation.
i
The PC/Laptop must be re-started, as otherwise the
Bluetooth Manager symbol
task bar.
"
The Bluetooth driver has been installed.
|
1 689 989 100 2011-11-18
does not appear in the
4.�.2 Configuring K�S �ruck MAC address
Before KTS Truck can communicate via Bluetooth with
the PC/Laptop (e.g. DCU 130), the KTS Truck MAC
address must be entered in ESI[tronic] 2.0.
i
The procedure is described on the basis of the
Toshiba Bluetooth Stack. The procedure may differ
for other Bluetooth drivers.
Determination of MAC address
1. Remove the USB connecting cable from KTS Truck.
2. Supply KTS Truck with power via the connecting
cable for the cigarette lighter socket or the B+/B–
battery cable.
3. Click onto the Bluetooth manager symbol
task bar with the right mouse key.
4. Select the "Bluetooth settings" menu item.
 The "Add New Connection Wizard" dialog
window is opened.
5. Select the option Express Mode (Recommended).
6. Select <Next>.
 Bluetooth devices are displayed.
i
If a Bluetooth connection to KTS Truck cannot be
established, disconnect KTS Truck from the power
supply and check whether the USB cable has been
disconnected. After this, connect KTS Truck to the
power once more and select <Refresh> in the "Add
New Connection Wizard" dialog window.
7. Select K�S �RUCK.
8. Select <Next>.
 The Bluetooth link is established.
 The "Bluetooth Manager – Bluetooth Security"
dialog window is opened.
9. Enter Bluetooth passkey (Pin)
10. Select <OK>.
 COM port is set.
in the
1234
.
Robert Bosch GmbH