Kenmore 41781912510 Instrucciones De Instalación página 7

Condensación secadora compacto
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Electrical connection (non-Canada) - 3 wire cord
(NEMA type 10-30R)
30 AMP
30 AMP
NEMA 10-30
NEMA 10-30
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could
result in personal injury or even death.
1 Turn off power supply to outlet.
2 Remove the three screws securing the terminal block
access cover in the upper corner on the back of the
dryer.
3 Using an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 10-30 type SRDT, attach the neutral (center
wire) conductor to the SILVER colored center terminal on
the terminal block. Tighten the screw securely.
NOTE
Terminal screws were shipped from the factory temporarily
attached inside the access cover.
4 Attach the remaining two power cord outer
conductors to the outer, BRASS colored terminals on
the terminal block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/conductor at
connections.
5 Reinstall the terminal block cover.
WARNING
ELECTRICAL SHOCK HAZARD
Do not operate dryer without terminal cover in place.
A correctly installed terminal block cover also acts a
qualifi ed strain relief for the power cord.
IMPORTANT
If moving dryer from a 4-wire system and installing it now
in a 3-wire system, move the internal ground wire from
the center terminal back to the GREEN screw under the
terminal block.
3-wire receptacle
Neutral
Neutral
(center wire)
(center wire)
Installation Instructions
7
terminal cover
access cover
screw
DO NOT
REMOVE THIS
SCREW
access cover
screw
access cover
screw
line 1 - L1
(BRASS terminal)
neutral - N
(SILVER terminal)
line 2 - L2
(BRASS terminal)
internal ground
(GREEN screw)
route cord here
neutral
terminal
DO NOT move
internal ground in
a 3-wire system!

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido