Mounting Module To P42, P43 And P44 Displays - Rockwell Automation Allen-Bradley 2706-PENI Instrucciones De Instalación

Mounting Module to P42,
P43 and P44 Displays
Be sure to place the wires so they are not caught by
TIP
screws when replacing the power supply cover, and
also so they do not interfere with fan operation.
7. Torque the cable grip until the cap is completely seated.
8. Replace the power supply back cover with the 6 screws (on
2706-P4x). Torque the screws to 2.7Nm (24 in-lbs).
Carefully close the sign and tighten the latches (on 2706-P7x).
9. Connect the power supply to a power source.
The InView EtherNet/IP and DeviceNet Interface module is designed
to mount to the track of the InView P42, P43 and P44 displays. The
back plate of the module has tabs for attaching to the track. Tighten
mounting screws until they bottom out against the back plate.
Back Plate
with Tabs
InView EtherNet/DeviceNet Module
Serial Cable
Power Line
For ease in mounting, rotate
module 90° so that the
mounting holes are on top and
bottom. Rotate the module
clockwise over track until the
alignment is horizontal.
Publication 2706-IN010C-MU-P
7