Location For Installation; Requirements For Communication Line; Select Communication Line For Indoor Unit And Wired Controller - Gree VRF Fresh Air Serie El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Multi Variable Air Conditioners Duct Type Indoor Unit

3.2 Location for Installation

(1) The top holder must be strong enough to support unit's weight.
(2) Drain pipe can drain water out easily.
(3) There is no obstacle at inlet or outlet. Please ensure good air circulation.
(4) In order to make sure the space for maintenance, please install the indoor unit according to
the dimension described below.
(5) Keep the unit away from heat source, inflammable gas or smoke.
(6) This is a concealed ceiling type unit.
(7) Indoor unit, outdoor unit, power cord and electric wire should stay at least 1m from the TV
set and radio. Otherwise, these electric appliances may have image interference and noise.
(Even if the distance is 1m, when there is strong electric wave, noise may still occur.)
Work area
Notes:
① Installation of the unit must be in accordance with National Electric Codes and local safety
regulations.
① Improper installation will affect unit's performance, so do not install the unit by yourself.
Please contact local dealer to arrange professional technicians for the installation.
① Do not connect power until all installation work is finished.

3.3 Requirements for Communication Line

Notes:
If the unit is installed in the place with strong electromagnetic interference, shielded wire must
be applied on the communication wire between indoor unit and wired controller. Twisted pair line with
shielding function must be applied on the communication wire between indoor unit and indoor unit
(outdoor unit).

3.3.1 Select communication line for indoor unit and wired controller

L02
Sub-master
Controller
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Air supply pipe
Work area
Return Air pipe
L1
L01
Master
L=L01+L02+L1+L2+......+L(n-1)(n≤16)
Controller
Fig 3.3.1
Air supply pipe
L2
6
Unit: mm
Ceiling
Return Air pipe
L(n-1)

Publicidad

Tabla de contenido
loading

Tabla de contenido