Napa CARLYLE DTW38 Instrucciones De Operación página 10

oPeRATING INSTRucTIoNS
• Torque Unit Setting
When the wrench is in Showing Torque Environment,
press "U" button then follow the arrow to select the unit.
Available Torque units : Ft-Lb/N.M./Kg-Cm/In-Lb
• Angle Unit Mode
When the inch pounds (In-Lb) unit is selected press "U"
to enter "Angle Unit Mode". Then wait for (- - - -) to be
displayed, (this indicates that the tool has found a home
position to take a measurement from) the unit will display
the last used setting.
CAUTION: Make sure that the tool is laying on a flat stable
surface when entering angle mode. This is to ensure the
tool can find a stable home position to take measurement
from, and that the resulting measurement is accurate.
1. Angle Display Mode :
The Angle measurement is held until 5% of full scale
torque value is applied. Rotation is accumulated in
angular degrees. When the applied torque is
released, the accumulated angle value will flash and
the buzzer will sound.
2. Angle Setting Mode :
Step 1. Press "+" button, increase Angle value.
Step 2. Press "-" button, decrease Angle value.
3. Return Preset angle value :
In Angle Measurement Mode, Press the "C" button
to return to the preset angle value.
4. Exit Angle Mode :
In Angle Setting mode, Press the "U" button to enter
the home screen that will display the last set torque
parameter.
1. Press "+" button to increase the torque alarm value.
2. Press "-" button to decrease the torque alarm value.
3. Press "U" button to select the unit.
4. Press "ON/OFF" button, the display shows full scale
of torque value.
Press "+" button, the display shows preset torque from 5%
of full scale, then start to increase to preset torque value.
Press "-" key, the display shows preset torque from 100%
of full scale, then start to decrease to preset torque value.
DTW38 and DTW12 10 Rev. 02/27/15