Switching On / Off; Working Instructions - ULTIMATE SPEED UMK 10 C2 Instrucciones De Utilización Y De Seguridad

Connecting the connection valve
Open the connection valve
(see Fig. B).
Connecting without valve adapter
- Insert the open connection valve
the inflatable (if necessary, first remove valve cover of
the inflatable).
- Hold the connection valve and close: push tensioning
lever toward connection valve
8
Connecting with valve adapter
- Push the respective valve adapter into the opening in
the connection valve
- Secure the valve adapter into the connection valve
push clamping lever
Fig. C).
- Insert the valve adapter
able (if necessary, first remove valve cover of the inflat-
able).

Switching on / off:

Switch the device on: on / off switch
Once the desired filling pressure has been reached,
switch the device off: on / off switch
Remove the cigarette lighter plug
:
7
: clamping lever vertical
7 8
:
10
into the valve of
7
.
7
:
10
.
7
toward connection valve (see
8
into the valve on the inflat-
10
to position "I".
6
to position "0".
6
.
5
Removing the connetion valve:
Connecting without valve adapter
ing lever for the connection valve
8
from the valve of the inflatable.
Connecting with valve adapter
adapter from the valve of the inflatable. Open the clamp-
ing lever of the connection valve
8
valve adapter
10
Note: Air may escape from the valve of the inflatable when
removing the connection valve
the connection valve
: The manometer
7
specialist facility with a calibrated device after inflating
inflatables where incorrect pressure can be dangerous
(e.g. car tyre).

Working instructions

This product is not suitable for continuous operation. It was
developed to produce air pressure, not air volume.
Do not use the product for longer than 5 minutes without
interruption to prevent overheating and damage to the
: Open the clamp-
10
and remove
7
: Remove the valve
10
and remove the
7
.
. Be sure not to remove
7
too quickly.
7
is not calibrated. Therefore seek a
2
GB/MT 51