Multi VRF Floor Standing Indoor Unit
As shown in Fig.II, install the stands of both ends of the panel into the slot and put the middle rotating shaft
into the groove, then place the panel and clasp back along the arrow direction.
8.2 Cleaning the air filters
(1) Disassembling the air filter
As shown in Fig. 7.2, take out the decorative strip at position①and unscrew the screw. After
opening the glass panel and unscrew the screws fixing the air filter. At last pull out the air filter
along the arrow direction.
(2) Cleaning the filter
Slightly flat the filter or clean the filter with electric cleaner. If there is too much dust on the
filter, clean it with a little neutral detergent or warm water. After that, dry the filter and reinstall it, as
shown in Fig.7.2.
Note:
Do not dry the filter by exposing it under direct sunshine or near a heating oven, or it may get deformed.
8.3 Check before the usage season
(1) Check if there is blockage in the inlet or outlet vent of the air conditioner.
(2) Check if the earth wire is earthed reliably.
(3) Check if the batteries in the wireless remote controller have been replaced.
(4) Check if the air filter has been installed properly
In order to start up the air conditioner smoothly after it has been turned off for a long time
period, energize the unit 8 hours before turning it on.
8.4 Check after the usage season
(1) Clean filter and body of air conditioner.
(2) Cut off the main power supply of air conditioner.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Fig. 7.2
16