Quick Start Guide
Casio Model Numbers PCR-272, 140CR
Initialize Your Cash Register
1
(See Page 9 in the User's Manual)
A)
Insert the supplied key and
turn to the "OFF" position.
PGM
OFF
Load the Memory Protection Batteries and Paper Roll
2
(See Page 9 - 10 in the User's Manual)
A)
Remove the printer cover.
6
IMPORTANT
Be sure that the plus (+) and minus (-) ends of the batteries
are facing in the directions indicated the illustration inside the
battery compartment.
No battery is included in the accessories.
Setting the Date and Time
3
(See Page 11 in the User's Manual)
A)
Using the key marked "PGM" turn
the key to the "PGM" position.
CAL X
REG
PGM
OFF
RF
PGM
Setting Tax Rates
4
(See Page 11 in the User's Manual)
Prepare the tax rate of your state. If your tax table has break point, refer to page 24 of the
user's manual.
Input the desired fl at tax rate to the appropriate department key.
A)
Turn the key to the "PGM" position.
REG
PGM
OFF
Press the ~ key.
B)
C)
Enter tax rate.
(Example: For 6% enter "6", 5.75% enter "5.75".)
D)
Press the appropriate department key.
E)
Repeat step C) and D) to set other department key.
Press the s key to end tax programming.
F)
Note: In case of setting the wrong tax rate to the key, please enter
ment keys above, and quit this procedure by pressing k key, and start from the begin-
ning of this procedure.
Please start with the department 2 key (taxable department). Department 1 key is initial-
ized as non taxable.
QSG260*ES
B)
Plug the power cord into an AC outlet.
CAL
X
Z
REG
RF
PGM
B)
Open battery compart-
C)
ment cover.
6
B)
When the display shows blinking
00-00-00
"0", such as
current date in Month, Day, Year
Z
order.
Example: January, 8, 2010,
?Z?<Z?
enter
• Enter 6-digit, last 2 digits for year set.
(2010 –>10)
• By pressing y key, this procedure
returns one by one.
CAL X
Z
RF
PGM
Please keep this sheet for future reference.
Also, visit http://casio4business.com/sa/support/index_support.html
Insert 3 new "AA" type batteries
in to the compartment.
REG
OFF
RF
00-00-00
, enter
00-00-00
01-00-00
01-00-00
01-08-00
01-08-10
01-08-10
?
and press those depart-
For Programming Assistance Please Call
TOLL FREE 1-800 638-9228
To prevent to lose all of your setting and sales data, we
recommended you to install the memory protection bat-
teries.
D)
Turn to the "REG" position. Install the supplied 58mm paper roll
placing the paper roll into the printer well. Insert the paper into the
inlet and press l key to set the paper.
CAL
X
Z
6
PGM
E)
Proceed to the Next step "Setting the Date and Time".
C)
When the display shows blinking
00-00
"0", such as
current time in Hour, Minute order.
Example: 1:18 PM, enter
ZCZ<.
• Enter 4-digit, use 24-hour system.
• By pressing y key, this procedure
returns one by one.
• If you want to adjust the date/time,
please refer to page 31 of the User's
Manual.
Example1: Set state tax 6% to department 2, 3 key
~
N
S
N
D
k
Example 2: Set state tax 5.5% to department 2 key and tax
7% to department 3 key
~
Start tax program
"B
B
S
Enter tax rate and press dept key.
M
D
Enter tax rate and press dept key.
k
To end the setting.
Quick Start Setup Completed!
5
6
00-00
, enter
10-00
13-00
13-10
13-18
~00
Start tax program
Enter tax rate and press dept key.
Enter tax rate and press dept key.
To end the setting.
0812-A