Best IBF4I36SB Manual De Instrucciones página 10

5. Measure the length of 6"
round metal duct required
from the damper / duct
connector to the ductwork
rough-in in the ceiling.
Connect the duct to the
damper / duct connector
and seal with duct tape.
6. Remove the protective
coating from the inner the
flue.
FOR CEILING HEIGHTS
7-FT. 8-IN. & 8-FT. ONLY:
Turn the inner flue so
that the louvers are at the
bottom.
FOR ALL CEILING
HEIGHTS:
Carefully slide the inner
flue down into the outer
flue. Slide the flues over
the angle brackets. Make
sure the side marked "front"
faces the control side of
the hood. Feed the power
cable up through the flues.
7. Attach the hood assembly
to the ceiling bracket using
(8) M4 x 10mm machine
screws (2 for each support
leg).
8. Connect metal duct to
ceiling duct and seal with
duct tape.
9. Connect power cable to
house wiring inside of
electrical outlet box. Black
to Black, White to White,
and Green to Green or
Bare wires. Secure power
cable to wiring box with
appropriate connector and
re-attach outlet box cover.
METAL
DUCT
LOUVERS
METAL
DUCT
DAMPER /
DUCT
CONNECTOR
(8) M4 x 10mm
PAN HEAD
MACHINE
SCREWS
- 10 -
INNER
FLUE
POWER
CABLE
OUTER
FLUE
DUCT
TAPE
F R
O N
T
POWER
CABLE