salmson SIRIUX home Instalacion Y Puesta En Servicio página 23

• The current type and voltage must correspond to the details on the name plate.
• Connect the Salmson-Connector (Fig. 4).
• Mains connection: L, N, PE
• Maximum back-up fuse: 10 A, slow.
• Earth the pump according to the regulations.
• The electrical connection must be made in accordance with VDE 0700/part 1 via a
fixed connecting cable, which is provided with a plug device or an all-pole switch
with a contact opening width of at least 3 mm.
• For drip protection and strain relief at the PG screwed connection, a connecting
cable with an adequate outside diameter is necessary (e.g. H05WF3G1.5 or
AVMH-3x1.5).
• When pumps are used in systems with water temperatures above 90°C, a suitably
heat-resistant connection line must be laid.
• The connection line is to be placed in such a way that it can under no
circumstances come into contact with the pipe and/or the pump and motor
housing.
• Dismantle the Salmson-Connector (Fig. 4), a screwdriver is required for this.
Switching frequency
• On/off switching operations via mains voltage ≤ 100/24 h
• ≤ 20/h for a switching frequency of 1 min. between switching on/off via mains
voltage.
Salmson
English
23