Night Mode - salmson SIRIUX home Instalacion Y Puesta En Servicio

English
Activation of the Fine pilot function
Press and turn the white button to select the symbol for the Fine pilot function.
Press and turn again to activate or deactivate Fine pilot.
Confirm setting by pressing the white button.
NOTE: If the control mode Δp-c is active while Fine pilot is activated, the control
mode automatically switches to Δp-v.
Factory setting: Fine pilot OFF

8.6 Night mode

Symbol for the night mode.
The Temperature sensor of the pump is able to detect when the boiler is in
« night mode ».
Then, the pump will revert to its pre-set operating curve as soon as an increase in
water temperature is detected.
8.7 Key lock (hold function)
The key lock locks the settings on the pump, thus protecting it from unintended
or unauthorized adjustments to the pump.
Activation of the hold function
Select the symbol for venting; this allows activation of the key lock by pressing
and turning the white button. Hold the white button down for 10 seconds. The
message «Hold» appears on the display.
By turning, the key lock can now be activated (ON) or deactivated (OFF).
If the key lock is activated, the pump settings cannot be changed. After 10
seconds the display shows power consumption and the power consumption meter
again. If the white button is pressed, «Hold» appears on the display.
To deactivate the key lock, repeat the steps as for activation.
Factory setting: Key lock OFF.
26
Function
inactivates
If the pump detects a significant drop of water
temperature, it automatically switches to its night curve
to avoid an unnecessary consumption of energy.
Function
inactivates
Hold
Function
Function
activates
Function
activates
05/2015