Restoring The Factory Settings - salmson SIRIUX home Instalacion Y Puesta En Servicio

NOTE: Key lock is not deactivated by switching off the pump. The power
consumption meter cannot be reset to the factory settings when key lock is
activated. Key lock is not activated automatically, e.g. after a set period of time
has passed.
8.8 Resetting the power consumption meter
In pump standby mode, press the white button for 10 seconds. The power
consumption meter sets itself to zero after the current meter reading on the
display has flashed five times.

8.9 Restoring the factory settings

When the pump is in standby mode, press the white button for 20 seconds, all LED
elements light up for 2 seconds. The factory setting (delivery condition) of the
pump is restored and the power consumption meter in the display is at zero.
NOTE: All settings and displays are retained if the mains supply is interrupted.
8.10 Flow or instantaneous power consumption indication
By turning the white button the indication will switch from W to m³/h.
NOTE: For duty points for which the flow cannot be measured accurately, the
display shows "<" or ">" in front of the respective value.
Salmson
instantaneous power consumption indication in W.
Display of effective flow in m³/h.
English
27