Safety Button (Activation / Deactivation Device); Throttle Control Lever; Throttle Safety Lever; Using The Machine - Mountfield BC 500 Li 48 Manual De Instrucciones

5. CONTROLS
5.1 SAFETY BUTTON (ACTIVATION
/ DEACTIVATION DEVICE)
Press this button (Fig. 7.C) to activate
and deactivate the machine's
electrical circuit; the corresponding
LED comes "ON" (Fig. 7.E).
Pressing the speed button (Fig.7.D)
sets the cutting speed and the 2
corresponding LEDs come "ON"
(Fig. 7.F). If work is interrupted
(without turning off the machine), on
resumption the machine will start
again at the previously set speed.
Lights off: the electrical circuit is com-
pletely deactivated (OFF).
IMPORTANT Do not keep
your finger on the button when
moving the machine to avoid
accidentally enabling the machine.
The "Warning" icon (Fig. 7.G) comes
ON in the event of machine fault (refer
to the troubleshooting table, par. 14).

5.2 THROTTLE CONTROL LEVER

Used to start and regulate cutting means speed.
Throttle safety lever allows the throttle
control lever to be used (Fig. 7.A); this is
only possible if the throttle safety lever is
pressed at the same time (Fig. 7.B).
The cutting means stops automatically
when the throttle safety lever is released.

5.3 THROTTLE SAFETY LEVER

Throttle safety lever (Fig. 7.B) allows the
throttle control lever to be used (Fig. 7.A).

6. USING THE MACHINE

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
6.1 PREPARATION
Before starting work
several checks and operations to ensure you
can work efficiently and in maximum safety:
1. make sure the battery is not
inserted in its housing;
2. place the machine in a stable
horizontal position on the ground;
3. choose the most suitable cutting means
for the job to be done (par. 4.3.1);
4. check the battery (par. 6.1.1);
5. wear the harness

6.1.1 Checking the battery

The machine is supplied without the battery.
Purchase the battery with the capacity that
most suits your operational requirements
and fully charge it according to the
instructions in the battery booklet.
The list of approved batteries for this machine
is found in the "Technical Data" table.
Before each use:
– check the battery charge status according
to the instructions in the battery booklet.
6.1.2 Using harnesses
The harness must be put on before
connecting the machine to the special
coupling and the belts must be adjusted
to suit the operator's height and build.
The belt (Fig. 9 A) should pass over the
right shoulder and follow the left side.
Never wear the harness across your
body. Wear it over just one shoulder so
you can rapidly move the machine away
from your body in case of danger.
EN - 11
it is necessary to carry out
correctly (par. 6.1.2).