Mountfield BC 500 Li 48 Manual De Instrucciones página 181

14. TROUBLESHOOTING
PROBLEM
1. When the safety
button is pressed,
the two green lights
do not come on
2. Pushing the safety
button, the LED
(Fig. 7.G) blinks
3. The motor stops during
work and the LED
(Fig. 7.G) blinks
4. The cutting means is
stationary when the
throttle control lever
and throttle safety
lever are engaged
5. Motor overheating
6. Mowing is difficult
7. Grass accumulates
around the rod housing
and cutting line head
8. The line is not released
when the cutting line
head hits the ground
9. The cutting means
comes into contact
with a foreign body.
10. Excessive noise and/or
vibration is experienced
whilst working
11. The machine gives off
smoke whilst working
12. Battery power
reserve is low
If problems persist after having performed the operations described above, contact your dealer.
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Low battery
Machine damaged
Grass caught under the
cutting means guard
The cutting means is not
in good condition
Too high grass is being cut
close to the ground
The line is stuck to itself
Not enough line on the
reel or reel empty
The line is worn and too short
The line is tangled on the reel or broken Remove the line from the reel
-
Loose or damaged parts.
Machine damaged
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Make sure the battery is inserted and
well fit in its housing (paragraph 7.2.3)
Check the battery status and
recharge if necessary (par. 7.2.2)
Check the battery status and
recharge if necessary (par. 7.2.2)
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Remove caught grass (par. 6.5)
Proceed with cutting means
maintenance (par. 8.1)
Cut tall grass with a top down
movement to avoid accumulations.
Lubricate with silicone spray
Replace the line (chapter 8.1.3.)
Pull the line while pressing the release button
and rewind it (chapter 8.1.3)
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Optimise operations
(par. 7.2.1)
Use a second battery or
battery (par. 15.1)
Purchase a new battery
EN - 18
SOLUTION
extended